Installation

FRONT SUSPENSION: FRONT UPPER SUSPENSION ARM: INSTALLATION

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure listed is for the LH side.

1. INSTALL FRONT UPPER SUSPENSION ARM ASSEMBLY

(a) Temporarily install the front upper suspension arm assembly with the 2 bolts.





HINT
When installing the front upper suspension arm assembly, temporarily tighten the bolts at the position shown in the illustration.

(b) Fully tighten the front upper suspension arm assembly with the 2 bolts.





Torque : 49 Nm (500 kgf-cm, 36 ft-lbf)

2. TEMPORARILY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING Installation

3. INSTALL FRONT UPPER SUSPENSION ARM ASSEMBLY Installation

4. INSTALL STEERING KNUCKLE WITH AXLE ASSEMBLY Installation

5. INSTALL FRONT DISC Installation

6. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY Installation

7. CONNECT FRONT SPEED SENSOR Installation

8. INSTALL FRONT STABILIZER LINK ASSEMBLY Installation

9. STABILIZE SUSPENSION Installation

10. FULLY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING Installation

11. INSTALL ENGINE ROOM SIDE COVER LH Installation

12. INSTALL COOL AIR INTAKE DUCT SEAL Installation

13. INSTALL FRONT WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

14. CHECK FOR SPEED SENSOR SIGNAL

HINT
Check for speed sensor signal. Test Mode Procedure

15. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT
Inspect and adjust front wheel alignment. Front Wheel Alignment