Removal

SEAT BELT: REAR SEAT OUTER BELT ASSEMBLY: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system Service Precautions.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE REAR SEAT HEADREST ASSEMBLY LH

3. REMOVE REAR SEAT HEADREST ASSEMBLY RH

4. REMOVE REAR SEAT CUSHION ASSEMBLY Removal

5. REMOVE REAR SEATBACK ASSEMBLY Removal

6. REMOVE REAR DOOR SCUFF PLATE LH Removal

7. REMOVE REAR DOOR SCUFF PLATE RH Removal

8. REMOVE REAR SEAT SIDE GARNISH LH Removal

9. REMOVE REAR SEAT SIDE GARNISH RH Removal

10. REMOVE ROOF SIDE INNER GARNISH LH Removal

11. REMOVE ROOF SIDE INNER GARNISH RH Removal

12. REMOVE CENTER STOP LIGHT SET Removal

13. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

(a) Remove the bolt and disconnect the floor end of the rear seat 3 point type belt assembly LH.





HINT
Use the same procedures for the RH side and the LH side.

(b) Using a moulding remover, disengage the 4 claws and remove the rear seat shoulder belt cover LH.





HINT
Use the same procedures for the RH side and LH side.

(c) Disengage the 3 clips.





(d) Pass the 2 rear seat belt floor anchors through the package tray trim panel assembly.

(e) Disengage the 5 claws and remove the package tray trim panel assembly.

14. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY

(a) Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner connector as shown in the illustration.





(b) Remove the 2 bolts and the rear seat 3 point type belt assembly.