Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: REAR AIRBAG SENSOR: INSTALLATION

1. INSTALL REAR AIRBAG SENSOR

(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Install the rear airbag sensor with the bolt and pin.





Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

NOTICE:
* If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
* When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
* Make sure that the pin is securely inserted into the body hole.
* Tighten the bolt while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.

(d) Connect the connector to the rear airbag sensor.

NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.

(e) Check that there is no looseness in the installation parts of the rear airbag sensor.

2. INSTALL REAR SEAT SIDE GARNISH Installation

3. INSTALL REAR DOOR SCUFF PLATE Installation

4. INSTALL REAR SEATBACK ASSEMBLY Installation

5. INSTALL REAR SEAT CUSHION ASSEMBLY Installation

6. INSTALL REAR SEAT HEADREST ASSEMBLY LH

7. INSTALL REAR SEAT HEADREST ASSEMBLY RH

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

9. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.