Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Front Passenger Side): INSTALLATION

1. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Connect the front passenger side knee airbag connector to the front passenger side knee airbag assembly.





NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.

(d) Install the front passenger side knee airbag assembly with the 3 bolts and claw.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

2. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

3. INSTALL SIDE INSTRUMENT PANEL RH Installation

4. INSTALL FRONT DOOR OPENING TRIM COVER RH

HINT
Use the same procedure for the RH side and LH side Installation.

5. INSTALL FRONT DOOR SCUFF PLATE RH

HINT
Use the same procedure for the RH side and LH side Installation.

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.