Removal

BRAKE SYSTEM (OTHER): BRAKE MASTER CYLINDER: REMOVAL

NOTICE:
Release the vacuum from the booster by depressing the brake pedal several times. Then remove the brake master cylinder sub-assembly from the brake booster assembly.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE COOL AIR INTAKE DUCT SEAL Removal

3. REMOVE ENGINE ROOM SIDE COVER LH Removal

4. DRAIN BRAKE FLUID

NOTICE:
If brake fluid leaks onto any painted surface, immediately wash it off.

5. REMOVE NO. 3 ENGINE ROOM RELAY BLOCK

(a) Remove the bolt, nut and No. 3 engine room relay block.

NOTICE:
Cover the No. 3 engine room relay block with a piece of cloth to prevent brake fluid from getting on it.

6. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

(a) Disengage the clamp and disconnect the connector.

(b) Using a union nut wrench (10 mm), disconnect the 2 brake lines from the brake master cylinder sub-assembly.

NOTICE:
Do not damage the brake lines.

(d) Remove the O-ring from the brake master cylinder sub-assembly.