Installation

BRAKE SYSTEM (OTHER): BRAKE MASTER CYLINDER: INSTALLATION

1. INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD Testing and Inspection

2. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

(a) Install a new O-ring to the brake master cylinder sub-assembly.

(b) Install the brake master cylinder sub-assembly to the booster assembly with the 2 nuts.





Torque : 13 Nm (133 kgf-cm, 10 ft-lbf)

(c) Using a union nut wrench (10 mm), connect the 2 brake lines to the brake master cylinder sub-assembly.





Text in Illustration





without a union nut wrench - Torque : 15 Nm (153 kgf-cm, 11 ft-lbf)

with a union nut wrench - Torque : 14 Nm (143 kgf-cm, 10 ft-lbf)

NOTICE:
* Use a torque wrench with a fulcrum length of 250 mm (9.84 in.)
* This torque value is effective when the union nut wrench is parallel to the torque wrench.

(d) Engage the clamp and connect the connector.





3. INSTALL NO. 3 ENGINE ROOM RELAY BLOCK

(a) Install the No. 3 engine room relay block with the bolt and nut.





Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

5. BLEED BRAKE SYSTEM

HINT
Service and Repair

6. INSTALL ENGINE ROOM SIDE COVER LH Installation

7. INSTALL COOL AIR INTAKE DUCT SEAL Installation