Installation

BRAKE (REAR): REAR BRAKE FLEXIBLE HOSE: INSTALLATION

1. INSTALL REAR FLEXIBLE HOSE

(a) Install the rear flexible hose to the rear disc brake cylinder assembly with the bolt and a new gasket.





Torque : 39 Nm (398 kgf-cm, 29 ft-lbf)

NOTICE:
Install the flexible hose lock securely in the lock hole in the rear disc brake cylinder assembly.

(b) Install a new clip to secure the rear flexible hose to the body bracket.

NOTICE:
Install the clip as far as it will go.

(c) Using a union nut wrench (10 mm), connect the rear flexible hose to the brake line.





without a union nut wrench - Torque : 15 Nm (153 kgf-cm, 11 ft-lbf)

with a union nut wrench - Torque : 14 Nm (143 kgf-cm, 10 ft-lbf)

NOTICE:
* Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
* This torque value is effective when the union nut wrench is parallel to the torque wrench.
* Do not kink or damage the brake line.
* Do not allow any foreign matter such as dirt and dust to enter the brake line.

2. FILL RESERVOIR WITH BRAKE FLUID Service and Repair

3. BLEED BRAKE LINE Service and Repair

4. INSPECT FOR BRAKE FLUID LEAK

5. INSPECT FLUID LEVEL IN RESERVOIR Testing and Inspection

6. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)