Installation

BRAKE (FRONT): FRONT BRAKE FLEXIBLE HOSE: INSTALLATION

1. INSTALL FRONT FLEXIBLE HOSE

(a) Install the front flexible hose to the front disc brake cylinder assembly with the bolt and a new gasket.





Torque : 39 Nm (398 kgf-cm, 29 ft-lbf)

NOTICE:
Install the flexible hose lock securely in the lock hole in the front disc brake cylinder assembly.

(b) Install a new clip to the front flexible hose.

NOTICE:
Install the clip as far as it will go.

(c) Using a union nut wrench (10 mm), connect the front flexible hose to the brake line.





without a union nut wrench - Torque : 15 Nm (153 kgf-cm, 11 ft-lbf)

with a union nut wrench - Torque : 14 Nm (143 kgf-cm, 10 ft-lbf)

NOTICE:
* Use a torque wrench with a fulcrum length of 250 mm (9.84 in.)
* This torque value is effective when the union nut wrench is parallel to the torque wrench.
* Do not kink or damage the brake line.
* Do not allow any foreign matter such as dirt or dust to enter the brake line from the clip or bracket.

2. FILL RESERVOIR WITH BRAKE FLUID Service and Repair

3. BLEED BRAKE LINE Service and Repair

4. INSPECT FOR BRAKE FLUID LEAK

5. INSPECT FLUID LEVEL IN RESERVOIR Testing and Inspection

6. INSTALL FRONT WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)