Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: INSTALLATION

1. INSTALL FRONT SPEED SENSOR

(a) Wipe off sealant attached to the front speed sensor's fitting surface with a non-residue solvent.

NOTICE:
Prevent foreign matter from attaching to the sensor rotor.

(b) Install a new front speed sensor to the hub and bearing assembly. The front speed sensor connector should be positioned upward.





(c) Using SST and a press, install the front speed sensor onto the front axle hub and bearing.





SST : 09214-76011

NOTICE:
* Keep the front speed sensor away from magnets.
* Do not use a hammer on the front speed sensor.
* Check that there is no foreign matter such as iron chips on the front speed sensor's detecting portion.
* Slowly press the front speed sensor straight.

2. INSTALL FRONT AXLE HUB SUB-ASSEMBLY WITH FRONT SPEED SENSOR Installation

3. INSPECT FRONT AXLE HUB BEARING FOR LOOSENESS Front Axle Hub

4. INSPECT FRONT AXLE HUB FOR RUNOUT Front Axle Hub

5. INSTALL FRONT DISC Installation

6. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY Installation

7. CONNECT FRONT SPEED SENSOR WIRE

(a) Connect the front speed sensor wire to the front speed sensor.

NOTICE:
Do not twist the sensor wire.





8. INSTALL FRONT WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

10. CHECK FOR SPEED SENSOR SIGNAL

HINT
Test Mode Procedure