Removal

2GR-FSE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL Removal

2. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

3. REMOVE NO. 1 INLET AIR CLEANER Removal

4. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM Service and Repair

5. REMOVE V-RIBBED BELT Removal

6. REMOVE ENGINE UNDER COVER

7. REMOVE REAR ENGINE UNDER COVER LH (for 2WD) Removal

8. REMOVE OIL FILTER BRACKET (for 4WD) Removal

9. REMOVE OIL FILTER BRACKET SUB-ASSEMBLY (for 4WD) Removal

10. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE Removal

11. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY Removal

12. REMOVE COMPRESSOR AND MAGNETIC CLUTCH (for 2WD) Removal

13. REMOVE COMPRESSOR AND MAGNETIC CLUTCH (for 4WD) Removal

14. REMOVE CRANKSHAFT POSITION SENSOR

(a) Disconnect the crankshaft position sensor connector.





(b) Remove the bolt and crankshaft position sensor.