Component Tests and General Diagnostics

DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY (for 4GR-FSE): INSPECTION

1. INSPECT PROPELLER SHAFT ASSEMBLY

(a) Using a dial indicator and V-block, inspect the runout of the propeller shaft assembly.





Maximum runout:

0.8 mm (0.0314 in.)

NOTICE:
The dial indicator must be set perpendicular to the center of the propeller shaft assembly.

HINT
If the shaft runout exceeds the maximum, replace the propeller shaft assembly.

2. INSPECT INTERMEDIATE SHAFT ASSEMBLY

(a) Using a dial indicator and V-block, inspect the runout of the intermediate shaft assembly.





Maximum runout:

0.8 mm (0.0314 in.)

NOTICE:
The dial indicator must be set perpendicular to the center of the intermediate shaft assembly.

HINT
If the shaft runout exceeds the maximum, replace the intermediate shaft assembly.

3. INSPECT SPIDER BEARING

(a) Check that the spider bearing rotates smoothly.





(b) Check that there is no play in the spider bearing.

HINT
If necessary, replace the intermediate shaft.

4. INSPECT NO. 1 CENTER SUPPORT BEARING ASSEMBLY

(a) Turn the center support bearing by hand in the rotating direction. Check that the center support bearing turns smoothly.





(b) Check that the center support bracket of the center support bearing is not cracked or deformed.

(c) Check that the seals are not cracked or damaged.

HINT
If the center support bearing is damaged, worn, or does not turn smoothly, replace it.