Replacement

AXLE AND DIFFERENTIAL: REAR AXLE HUB BOLT: REPLACEMENT

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. REMOVE REAR WHEEL

2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY Disassembly

3. REMOVE REAR NO. 1 DISC BRAKE CALIPER PLATE Removal

4. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

5. REMOVE REAR DISC Removal

6. REMOVE REAR AXLE HUB BOLT

(a) Temporarily install 2 nuts to the rear axle hub bolt as shown in the illustration.





Text in Illustration





NOTICE:
Install the nuts to prevent damage to the rear axle hub bolts.

(b) Using SST and a screwdriver or an equivalent tool to hold the rear axle hub and bearing assembly, remove the rear axle hub bolt.

SST : 09628-10011

NOTICE:
Do not damage the threads of the rear axle hub bolts.

7. INSTALL REAR AXLE HUB BOLT

(a) Temporarily install a new rear axle hub bolt to the rear axle hub and bearing assembly.





Text in Illustration





(b) Install a washer and nut to the new rear axle hub bolt as shown in the illustration.

HINT
The thickness of the washer is preferably 5 mm (0.197 in.) or more.

(c) Using a screwdriver or an equivalent tool to hold the rear axle hub and bearing assembly, install the rear axle hub bolt by tightening the nut.

NOTICE:
* Install the nuts to prevent damage to the rear axle hub bolts.
* Do not damage the threads of the rear axle hub bolts.

(d) Remove the 3 nuts and washer from the 3 rear axle hub bolts.

8. INSTALL REAR DISC Installation

9. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG

10. INSTALL REAR NO. 1 DISC BRAKE CALIPER PLATE Installation

11. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY Reassembly

12. ADJUST PARKING BRAKE

Adjustments.

13. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)