Installation

BRAKE (REAR): REAR BRAKE FLEXIBLE HOSE: INSTALLATION

NOTICE:
* Because the left and right hoses are not interchangeable, verify the part number when installing the flexible hoses.
* If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure is for the LH side.

1. INSTALL REAR FLEXIBLE HOSE

(a) Install the rear flexible hose to the rear disc brake cylinder assembly with the union bolt and a new gasket.





Torque : 30 Nm (310 kgf-cm, 22 ft-lbf)

NOTICE:
Install the flexible hose lock securely in the lock hole in the rear disc brake cylinder assembly.

(b) Install a new clip to secure the rear flexible hose to the body bracket.

Text in Illustration





NOTICE:
Install the clip as far as it will go.

(c) Using a union nut wrench, connect the brake line to the rear flexible hose.

Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)

NOTICE:
* Do not bend or damage the brake line.
* Do not allow any foreign matter such as dirt and dust to enter the brake line.
* Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench Service Precautions.

2. BLEED BRAKE SYSTEM

HINT
Service and Repair

3. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)