Rear View Monitor System

PARK ASSIST / MONITORING: REAR VIEW MONITOR SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING

HINT
Use the following procedure to troubleshoot the rear view monitor system.

1. VEHICLE BROUGHT TO WORKSHOP

NEXT -- Continue to next step.

2. INSPECT BATTERY VOLTAGE

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

NEXT -- Continue to next step.

3. CUSTOMER PROBLEM ANALYSIS

NEXT -- Continue to next step.

4. CHECK AND CLEAR DTCs

(a) Refer to DTC check/clear Rear View Monitor System.

NEXT -- Continue to next step.

5. PROBLEM SYMPTOM CONFIRMATION

Result:





B -- Go to step 7
A -- Continue to next step.

6. SYMPTOM SIMULATION

NEXT -- Continue to next step.

7. CHECK DTC

Result:





B -- Go to step 11
A -- Continue to next step.

8. CHECK IF SAME SYMPTOM APPEARS IN NAVIGATION SYSTEM

(a) Check the navigation system.

* Navigation system (for HDD) Problem Symptoms Table

* Navigation system (for DVD) Problem Symptoms Table

Result:





B -- GO TO NAVIGATION SYSTEM (FOR HDD) (FOLLOW NAVIGATION SYMPTOM CHART TO PERFORM TROUBLESHOOTING)

C -- GO TO NAVIGATION SYSTEM (FOR DVD) (FOLLOW NAVIGATION SYMPTOM CHART TO PERFORM TROUBLESHOOTING)
A -- Continue to next step.

9. PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table Problem Symptoms Table.

Result:





B -- Go to step 12
A -- Continue to next step.

10. OVERALL ANALYSIS AND TROUBLESHOOTING

(a) Terminals of ECU Rear View Monitor System (w/o Navigation System)

NEXT -- Continue to next step.

11. CIRCUIT INSPECTION

NEXT -- Continue to next step.

12. ADJUST, REPAIR OR REPLACE

NEXT -- Continue to next step.

13. CONFIRMATION TEST

NEXT -- END