Installation

UF1AE TRANSFER: TRANSFER CONTROL SOLENOID: INSTALLATION

1. INSTALL TRANSFER CONTROL SOLENOID

(a) Install the transfer control solenoid and solenoid lock plate to the transfer upper valve body with the bolt.





Torque : 6.4 Nm (65 kgf-cm, 57 in-lbf)

HINT
Install the solenoid lock plate into the cutout on the transfer control solenoid.

2. INSTALL TRANSFER VALVE BODY ASSEMBLY Installation

3. INSTALL TRANSFER OIL PAN Installation

4. INSTALL TRANSFER DYNAMIC DAMPER Installation

5. INSTALL ENGINE REAR MOUNTING MEMBER Installation

6. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR (for 4GR-FSE) Installation

7. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR (for 2GR-FSE) Installation

8. INSTALL FRONT EXHAUST PIPE ASSEMBLY (for 4GR-FSE) Installation

9. INSTALL FRONT EXHAUST PIPE ASSEMBLY (for 2GR-FSE) Installation

10. INSTALL HEATED OXYGEN SENSOR (for 4GR-FSE) Installation

11. INSTALL HEATED OXYGEN SENSOR (for 2GR-FSE) Installation

12. INSTALL FRONT CENTER FLOOR BRACE (for 4GR-FSE) Installation

13. INSTALL FRONT CENTER FLOOR BRACE (for 2GR-FSE) Installation

14. INSTALL REAR NO. 1 FLOOR PANEL BRACE (for 4GR-FSE) Installation

15. INSTALL REAR NO. 1 FLOOR PANEL BRACE (for 2GR-FSE) Installation

16. ADD AUTOMATIC TRANSMISSION FLUID Installation

17. CHECK FOR EXHAUST GAS LEAKS