Installation

STEERING COLUMN: MULTIPLEX TILT AND TELESCOPIC ECU: INSTALLATION

1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU

(a) Install the multiplex tilt and telescopic ECU with the 2 screws.





Torque : 1.5 Nm (15 kgf-cm, 13 in-lbf)

(b) Connect the connector to the multiplex tilt and telescopic ECU.

NOTICE:
* The connectors on both ends of the wire harness between the telescopic motor and ECU are the same shape.
* When installing them, connect the connectors of the same color.

2. INSTALL STEERING LOCK ACTUATOR ASSEMBLY

(a) Temporarily install the steering lock actuator assembly with 2 new tapered-head bolts.

(b) Tighten the 2 tapered-head bolts until the bolt heads break off.





3. INSTALL STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column)

HINT
Refer to the instructions for Installation of the steering column assembly (for Power Tilt and Power Telescopic) Installation.