Removal

4GR-FSE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL Removal

2. REMOVE ENGINE ROOM SIDE COVER LH Removal

3. REMOVE ENGINE ROOM SIDE COVER RH Removal

4. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

5. DISCHARGE REFRIGERANT FROM REFRIGERATION Service and Repair

6. REMOVE NO. 1 INLET AIR CLEANER Removal

7. REMOVE V-RIBBED BELT Removal

8. REMOVE ENGINE UNDER COVER

9. REMOVE REAR ENGINE UNDER COVER LH

10. REMOVE OIL FILTER BRACKET (for 4WD) Removal

11. REMOVE OIL FILTER BRACKET SUB-ASSEMBLY (for 4WD) Removal

12. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE Removal

13. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY Removal

14. REMOVE COMPRESSOR AND MAGNETIC CLUTCH (for 2WD) Removal

15. REMOVE COMPRESSOR AND MAGNETIC CLUTCH (for 4WD) Removal

16. REMOVE CRANKSHAFT POSITION SENSOR

(a) Disconnect the crankshaft position sensor connector.





(b) Remove the bolt and crankshaft position sensor.