Installation

SUPPLEMENTAL RESTRAINT SYSTEM: FRONT SEAT SIDE AIRBAG ASSEMBLY (for Manual Seat): INSTALLATION

CAUTION:
Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.

HINT
Use the same procedures for the LH side and RH side.

1. INSTALL FRONT SEAT SIDE AIRBAG ASSEMBLY

CAUTION:
* The nuts must not be reused.
* Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.
(a) Install the front seat side airbag assembly with 2 new nuts.





Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

(b) Connect the 2 clamps.

(c) Connect the 5 wire harness clamps to under the seat.





2. INSTALL FRONT SEATBACK COVER WITH PAD Reassembly

3. INSTALL FRONT SEAT HEADREST SUPPORT Reassembly

4. INSTALL FRONT SEAT HEADREST SUPPORT

5. INSTALL FRONT SEAT ASSEMBLY Installation

6. INSTALL REAR INNER SEAT TRACK COVER Installation

7. INSTALL REAR OUTER SEAT TRACK COVER Installation

8. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER Installation

9. INSTALL FRONT INNER SEAT TRACK BRACKET COVER Installation

10. INSTALL FRONT SEAT HEADREST ASSEMBLY

11. INSPECT SLIDE ADJUSTER LOCK

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

13. CHECK SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.