Green and Red Indicators Blink Simultaneously

CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: GREEN AND RED INDICATORS BLINK SIMULTANEOUSLY
- GREEN AND RED INDICATORS BLINK SIMULTANEOUSLY

DESCRIPTION

After the engine switch on (IG), the DCM (Telematics Transceiver) will enter into a self check mode. The manual (SOS) switch red indicator will illuminate for 2 seconds and turn off followed by the manual (SOS) switch green indicator illuminating and remaining on under normal operation.

If both indicators illuminate and begin to blink simultaneously, this indicates that the DCM (Telematics Transceiver) is in "Shipping Mode." If no DTCs are present, both the green and red indicators will turn off after blinking. The activation sequence must be performed.

HINT
In shipping mode, the system will attempt to activate to shell mode automatically at each engine switch on (IG).

INSPECTION PROCEDURE

PROCEDURE

1. CHANGE SUBSCRIPTION MODE

(a) Turn the engine switch on (IG).

(b) Push the manual (SOS) switch.

(c) The vehicle will issue a voice prompt: "Safety Connect is not initialized. To activate, please press the button again within 5 seconds."

(d) Push the manual (SOS) switch and a beep will be emitted.

(e) The telematics service provider will send an End Call command and the manual (SOS) switch green indicator will illuminate.

(f) A voice prompt will state: "Activation Complete" (This may take up to 3 minutes)

(g) Turn the engine switch off.

NEXT -- Continue to next step.

2. CHECK SUBSCRIPTION MODE

(a) Turn the engine switch on (IG).

(b) Confirm the manual (SOS) switch red indicator illuminates for 2 seconds and turns off and the manual (SOS) switch green indicator illuminates and remains on System Description.

NEXT -- END