Installation

4GR-FSE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR

(a) Apply a coat of engine oil to an O-ring of the crankshaft position sensor.

(b) Install the crankshaft position sensor with the bolt.





Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(c) Connect the crankshaft position sensor connector.

2. INSTALL COMPRESSOR AND MAGNETIC CLUTCH (for 2WD) Installation

3. INSTALL COMPRESSOR AND MAGNETIC CLUTCH (for 4WD) Installation

4. INSTALL DISCHARGE HOSE SUB-ASSEMBLY Installation

5. INSTALL NO. 1 COOLER REFRIGERANT SUCTION HOSE Installation

6. INSTALL OIL FILTER BRACKET SUB-ASSEMBLY (for 4WD) Installation

7. INSTALL OIL FILTER BRACKET (for 4WD) Reassembly

8. INSTALL V-RIBBED BELT Installation

9. INSTALL REAR ENGINE UNDER COVER LH (for 2WD) Installation

10. INSTALL ENGINE UNDER COVER

11. INSTALL NO. 1 INLET AIR CLEANER Installation

12. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

13. INSTALL ENGINE ROOM SIDE COVER LH Installation

14. INSTALL ENGINE ROOM SIDE COVER RH Installation

15. CHARGE REFRIGERANT Service and Repair

16. WARM UP ENGINE Service and Repair

17. CHECK FOR LEAKAGE OF REFRIGERANT Service and Repair