Removal

TIRE AND WHEEL: TIRE PRESSURE WARNING VALVE AND TRANSMITTER: REMOVAL

1. REMOVE FRONT WHEEL

2. REMOVE REAR WHEEL

3. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER

(a) Remove the valve core and cap, and release the air from the tire.

(b) After ensuring that a sufficient amount of air has been released, remove the nut and washer that is used to secure the tire pressure warning valve and transmitter and drop the sensor inside the tire.

HINT
Keep the removed cap, valve core, nut and washer.

(c) After dropping the tire pressure warning valve and transmitter into the tire, disengage the bead using the shoe of the tire remover.





NOTICE:
Be careful not to damage the tire pressure warning valve and transmitter due to interference between the sensor and tire bead.

(d) Remove the bead on the upper side in the usual way.

(e) Take out the sensor from the tire and remove the bead on the lower side in the usual way.

(f) Remove the inner grommet from the tire pressure warning valve and transmitter.

HINT
Check that no cracks or damage are identified on the grommet. If necessary, replace the grommet, the washer and the nut.