Installation

4GR-FSE ENGINE CONTROL SYSTEM: ENGINE COOLANT TEMPERATURE SENSOR: INSTALLATION

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR

(a) Install a new gasket to the engine coolant temperature sensor.

(b) Install the engine coolant temperature sensor.





Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

(c) Connect the engine coolant temperature sensor connector.

2. INSTALL INTAKE MANIFOLD Installation

3. INSTALL INTAKE AIR SURGE TANK ASSEMBLY Installation

4. INSTALL COLD START INJECTOR Installation

5. INSTALL THROTTLE BODY Installation

6. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE Installation

7. CONNECT NO. 2 VENTILATION HOSE Installation

8. ADD ENGINE COOLANT Testing and Inspection

9. INSPECT FOR COOLANT LEAK Testing and Inspection

10. INSPECT FOR FUEL LEAK Fuel System

11. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation

12. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH Installation

13. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH Installation

14. INSTALL FRONT WIPER ARM HEAD CAP Installation

15. INSTALL ROOF DRIP SIDE FINISH MOULDING RH

16. INSTALL ROOF DRIP SIDE FINISH MOULDING LH

17. INSTALL FRONT FENDER PROTECTOR UPPER RH Installation

18. INSTALL FRONT FENDER PROTECTOR UPPER LH Installation

19. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

20. INSTALL ENGINE ROOM SIDE COVER LH Installation

21. INSTALL ENGINE ROOM SIDE COVER RH Installation

22. INSTALL COOL AIR INTAKE DUCT SEAL Installation