Installation

BRAKE: REAR BRAKE FLEXIBLE HOSE: INSTALLATION

1. INSTALL REAR BRAKE FLEXIBLE HOSE

(a) Connect the rear brake flexible hose with the union bolt and a new gasket.





Torque : 30 Nm (310 kgf-cm, 22 ft-lbf)

NOTICE:
Install the flexible hose lock securely in the lock hole in the rear disc brake cylinder assembly.

(b) Connect the brake tube to rear brake flexible hose with a union nut wrench (10 mm) while holding the rear brake flexible hose with a wrench.

Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)

NOTICE:
* Do not bend or damage the brake line.
* Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting points.

(c) Install the flexible hose with a new clip.

NOTICE:
* When installing the rear brake flexible hose, face the identification mark to the outside of the vehicle and minimize twisting of the hose.
* Install the clip as far as it will go.

2. FILL RESERVOIR WITH BRAKE FLUID Service and Repair

3. BLEED BRAKE LINE Service and Repair

4. BLEED BRAKE ACTUATOR ASSEMBLY Service and Repair

5. INSPECT FLUID LEVEL IN RESERVOIR Service and Repair

6. INSPECT FOR BRAKE FLUID LEAK

7. INSTALL REAR WHEEL

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)