DTC CB-10

AUDIO / VISUAL: AUDIO AND VISUAL SYSTEM (w/o Navigation System without Multi-display): CB-10-CB-12: System Microcomputer Malfunction
CB-12 - CD-LSI Malfunction

DESCRIPTION





INSPECTION PROCEDURE

HINT
After the inspection is completed, clear the DTCs.

PROCEDURE

1. REPLACE USB DEVICE OR "iPod"

(a) Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

(b) Turn the engine switch off.

HINT
When one of these DTCs has been stored, it is necessary to turn off the engine switch to make it possible for the vehicle to recognize a new device when it is connected.

(c) Turn the engine switch on (ACC).

(d) Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

NEXT -- Continue to next step.

2. CLEAR DTC

(a) Clear the DTCs Audio And Visual System (w/o Navigation System without Multi-display).

NEXT -- Continue to next step.

3. RECHECK FOR DTC

(a) Recheck for DTCs and check if the same DTC is output again.

HINT
If DTCs are detected frequently, replace the multi-media interface ECU.

OK:

No DTCs are output.

NG -- REPLACE MULTI-MEDIA INTERFACE ECU Removal

OK -- USB DEVICE OR "iPod" WAS DEFECTIVE