Replacement

P311 HYBRID TRANSMISSION / TRANSAXLE: HYBRID TRANSAXLE OIL SEAL: REPLACEMENT

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. REMOVE FRONT WHEELS

2. REMOVE REAR ENGINE UNDER COVER LH

3. DRAIN HYBRID TRANSAXLE FLUID Procedures

4. SEPARATE FRONT SPEED SENSOR Removal

5. SEPARATE FRONT FLEXIBLE HOSE Removal

6. SEPARATE TIE ROD END SUB-ASSEMBLY Removal

7. REMOVE FRONT AXLE SHAFT NUT Removal

8. SEPARATE FRONT STABILIZER LINK ASSEMBLY Removal

9. SEPARATE FRONT NO. 1 LOWER SUSPENSION ARM SUB-ASSEMBLY Removal

10. SEPARATE FRONT DRIVE SHAFT ASSEMBLY Removal

11. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH Removal

12. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH Removal

13. REMOVE FRONT DRIVE SHAFT LH HOLE SNAP RING Removal

14. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY TYPE T OIL SEAL

(a) Remove the left side oil seal.





(1) Using SST, remove the oil seal.

SST : 09514-35011

Text in Illustration





(b) Remove the right side oil seal.





(1) Using SST, remove the oil seal.

SST : 09612-30012

Text in Illustration





15. INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY TYPE T OIL SEAL

(a) Install a new left side oil seal.





(1) Using SST and a hammer, tap in a new oil seal.

SST : 09223-15020

SST : 09950-70010

09951-07200

Oil seal driven in depth:

-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

(2) Coat the lip of the oil seal with MP grease.

(b) Install a new right side oil seal.





(1) Using SST and a hammer, tap in a new oil seal.

SST : 09223-00010

Oil seal driven in depth:

-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

(2) Coat the lip of the oil seal with MP grease.

16. INSTALL FRONT DRIVE SHAFT LH HOLE SNAP RING Installation

17. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH Installation

18. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH Installation

19. INSTALL FRONT STABILIZER LINK ASSEMBLY Installation

20. INSTALL FRONT NO. 1 LOWER SUSPENSION ARM SUB-ASSEMBLY Installation

21. INSTALL TIE ROD END SUB-ASSEMBLY Installation

22. INSTALL FRONT SPEED SENSOR Installation

23. INSTALL FRONT FLEXIBLE HOSE Installation

24. INSTALL FRONT AXLE SHAFT NUT Installation

25. ADD HYBRID TRANSAXLE FLUID Procedures

26. INSPECT AND ADJUST HYBRID TRANSAXLE FLUID Procedures

27. INSTALL FRONT WHEELS Installation

28. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT
Front Wheel Alignment

29. INSTALL REAR ENGINE UNDER COVER LH

30. INSPECT ABS SPEED SENSOR SIGNAL

HINT
Test Mode Procedure