Installation

AXLE AND DIFFERENTIAL: STEERING KNUCKLE: INSTALLATION

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. INSTALL STEERING KNUCKLE

(a) Secure the steering knuckle between aluminium plates in a vise.

NOTICE:
Do not overtighten the vise.

(b) Install the front axle hub sub-assembly and front disc brake dust cover with the 4 bolts.

Torque : 96 Nm (979 kgf-cm, 71 ft-lbf)

2. INSTALL FRONT LOWER BALL JOINT ASSEMBLY Installation

3. INSTALL FRONT AXLE ASSEMBLY

HINT
Refer to the procedures from Install Front Axle Assembly Installation.