Removal

2AZ-FXE EMISSION CONTROL: CANISTER: REMOVAL

1. PRECAUTION

NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY

(a) Remove the rear suspension member sub-assembly Removal.

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL Removal

4. REMOVE CHARCOAL CANISTER ASSEMBLY

(a) Using a screwdriver, pry up the retainer.





Text in Illustration





HINT
* Do not remove the retainer.
* Tape the screwdriver tip before use.

(b) Disconnect the purge line hose, air inlet line tube and wire harness connector.

(c) Disconnect the vent line tube.

NOTICE:
* Remove any dirt or foreign matter on the vent line tube connector before performing this work.






Text in Illustration





* Do not allow any scratches or foreign matter on the parts when disconnecting them as the vent line tube connector has an O-ring that seals the pipe.
* Perform this work by hand. Do not use any tools.
* Do not forcibly bend, twist or turn the nylon tube.
* Protect the disconnected parts by covering them with a plastic bags after disconnecting the vent line tube and pipe.
* If the vent line tube connector and pipe are stuck, push and pull to release them.

(d) Remove the 3 bolts, clip and charcoal canister assembly.