Installation

P410 HYBRID TRANSMISSION / TRANSAXLE: SHIFT CONTROL ACTUATOR: INSTALLATION

1. INSTALL SHIFT CONTROL ACTUATOR SEAL

NOTICE:
It is not always necessary to replace or remove/install the shift control actuator seal at the same time when replacing the shift control actuator assembly.

HINT
Remove/install the shift control actuator seal only if oil leaks from the shift control actuator seal or other faults are found when the shift control actuator assembly is removed.

(a) Using SST and a hammer, tap in a new shift control actuator seal.





SST : 09820-00031

Seal installation depth:

8.5 to 9.8 mm (0.335 to 0.386 in.)

Text in Illustration





2. INSTALL SHIFT CONTROL ACTUATOR ASSEMBLY

(a) Install the shift control actuator assembly with 3 new shift control actuator bolts.





Torque : 9.5 Nm (97 kgf-cm, 84 in-lbf)

(b) Install 3 new shift control actuator bolt caps to the shift control actuator bolts.





NOTICE:
Push in each shift control actuator cap firmly until the claw of the shift control actuator bolt cap engages with the control actuator bolt.

(c) Connect the connector to the shift control actuator assembly.

3. INSTALL NO. 1 ENGINE UNDER COVER