Removal

P410 HYBRID TRANSMISSION / TRANSAXLE: GENERATOR CABLE: REMOVAL

1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Service Precautions.

2. REMOVE REAR NO. 2 FLOOR BOARD Removal

3. REMOVE REAR DECK FLOOR BOX Removal

4. REMOVE REAR NO. 3 FLOOR BOARD Removal

5. REMOVE DECK FLOOR BOX RH Removal

6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE Removal

7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. REMOVE SERVICE PLUG GRIP Removal

9. REMOVE FRONT LOWER BUMPER ABSORBER

10. REMOVE NO. 1 ENGINE UNDER COVER

11. DRAIN COOLANT (for Engine) Coolant (For Engine)

12. DRAIN COOLANT (for Inverter) Coolant (For Inverter)

13. REMOVE INVERTER COVER ASSEMBLY LH (w/ Cover) Removal

14. REMOVE RADIATOR SUPPORT OPENING COVER Removal

15. REMOVE NO. 1 INVERTER BRACKET Removal

16. DISCONNECT ENGINE ROOM MAIN WIRE Removal

17. REMOVE INVERTER COVER Removal

18. CHECK TERMINAL VOLTAGE Removal

19. DISCONNECT FRAME WIRE Removal

20. DISCONNECT GENERATOR CABLE Removal

21. DISCONNECT MOTOR CABLE Removal

22. DISCONNECT NO. 2 ENGINE WIRE Removal

23. INSTALL INVERTER COVER Removal

24. DISCONNECT NO. 2 ENGINE ROOM WIRE Removal

25. DISCONNECT WATER HOSE Removal

26. REMOVE INVERTER WITH CONVERTER ASSEMBLY Removal

27. REMOVE INVERTER RESERVE TANK ASSEMBLY Removal

28. REMOVE INVERTER TRAY BRACKET Removal

29. REMOVE RADIATOR PIPE

(a) Disconnect the 3 clamps, No. 1 radiator hose, No. 4 water by-pass hose and No. 3 radiator hose.

(b) Remove the 2 bolts and radiator pipe.

30. REMOVE GENERATOR CABLE

NOTICE:
Wear insulated gloves.

(a) Disconnect the generator cable clamp from the motor cable bracket.

(b) Remove the 3 bolts and slide the generator cable connector shell back.

(d) Remove the 3 bolts and generator cable from the hybrid transaxle assembly.