Replacement

P410 HYBRID TRANSMISSION / TRANSAXLE: INPUT SHAFT OIL SEAL: REPLACEMENT

1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY

Removal

2. REMOVE INPUT SHAFT TYPE T OIL SEAL

(a) Using a screwdriver with its tip taped, remove the oil seal.





Text in Illustration





NOTICE:
When removing the oil seal, make sure not to damage the input shaft or hybrid vehicle transaxle housing.

3. INSTALL INPUT SHAFT TYPE T OIL SEAL

(a) Coat the lip of a new oil seal with MP grease.





(b) Using SST and a hammer, tap in the oil seal.

SST : 09330-50010

Oil seal installation depth:

1.0 to 1.8 mm (0.0394 to 0.0709 in.)

NOTICE:
* Ensure that no foreign matter adheres to the oil seal lip.
* Ensure that the oil seal is not at an angle.

4. INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY

Installation