Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT AIRBAG SENSOR: INSTALLATION

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. INSTALL FRONT AIRBAG SENSOR

(a) Check that the power switch is off.

(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

(c) Insert the pin (stopper) into the body hole and install the front airbag sensor with the bolt.

Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

NOTICE:
* If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
* When installing the front airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
* Make sure that the pin (stopper) is securely inserted into the body hole.
* Tighten the bolt while holding the front airbag sensor because the front airbag sensor pin (stopper) is easily damaged.

(d) Connect the connector to the front airbag sensor.

NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.

(1) Before connecting the connector, check that the position of the white housing lock is correct as shown in the illustration.





(2) Be sure to engage the connectors until they are locked (when locking, make sure that a click sound can be heard).





Text in Illustration





HINT
When engaged, the white housing lock will slide. Be sure not to hold the white housing lock and part (A), as it may result in an insecure fit.

(e) Check that there is no looseness in the installation parts of the front airbag sensor.

2. INSTALL HEADLIGHT ASSEMBLY

for Halogen Headlight: Installation

for LED Headlight: Installation

3. INSTALL FRONT FENDER SIDE PANEL PROTECTOR Installation

4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE Installation

6. INSTALL DECK FLOOR BOX RH Installation

7. INSTALL REAR NO. 3 FLOOR BOARD Installation

8. INSTALL REAR DECK FLOOR BOX Installation

9. INSTALL REAR NO. 2 FLOOR BOARD Installation

10. INSTALL FRONT BUMPER ASSEMBLY

Installation

11. INSPECT AND ADJUST HEADLIGHT AIMING

for Halogen Headlight: (For Halogen Headlight)

for LED Headlight: (For LED Headlight)

12. PERFORM DIAGNOSTIC SYSTEM CHECK

Reading and Clearing Diagnostic Trouble Codes

13. INSPECT SRS WARNING LIGHT

Diagnosis System