Engine - MIL ON, Misfire DTC's Set, Engine Knock On Cold Start

L-SB-0004-13

January 23, 2013

MIL "ON" DTC P030 # After Cold Soak

Service Category
Engine/Hybrid System

Section
Engine Mechanical

Market
USA





Applicability

Introduction

Some 2011 - 2013 model year CT 200h vehicles may exhibit one or more of the following conditions at initial engine start after cold soak in temperatures below 40°F (4.5°C):

^ MIL "ON" with Diagnostic Trouble Codes (DTCs) P0300, P0301, P0302, P0303. and/or P0304.

^ Initially runs rough.

^ Loud engine knock or rattle noise.

Production Change Information





This bulletin applies to vehicles produced BEFORE the Production Change Effective VIN shown.





Parts Information





Warranty Information





Required Tools & Equipment

1. Use Techstream to check for DTCs and confirm the condition per the Introduction.

2. Remove and replace the intake manifold with the updated part.

Refer to the Technical Information System (TIS) applicable model and model year Repair Manual:

^ 2011 CT 200h:
Engine/Hybrid System - Intake/Exhaust - "2ZR-FXE Intake / Exhaust: Intake Manifold: Removal / Installation

^ 2012 CT 200h:
Engine/Hybrid System - Intake/Exhaust - "2ZR-FXE Intake / Exhaust: Intake Manifold: Removal / Installation

^ 2013 CT 200h:
Engine/Hybrid System - Intake/Exhaust - "2ZR-FXE Intake / Exhaust: Intake Manifold: Removal / Installation

3. Clear the DTC(s) and verify normal vehicle operation.

©2013 Lexus, a division of Toyota Motor Sales, USA