Canada - Interior - Loose Trim Material Around POWER Button

L-TCI-3242

October 29, 2012

LOOSE TRIM PANEL MATERIAL SURROUNDING THE
POWER BUTTON SWITCH

Service Category
Vehicle Interior

Section
Interior Panels/Trim

Market
Canada





APPLICABILITY:

INTRODUCTION:





Some 2011 - 2012 model year CT 200h vehicles may exhibit a loose material condition surrounding the POWER button on the Meter Hood Sub-assembly. Replace the Meter Hood Sub-Assembly to address this condition.

PRODUCTION CHANGE INFORMATION:





This TSB applies to vehicles produced BEFORE the Production Change Effective VIN shown.





PARTS INFORMATION:





REQUIRED TOOLS & EQUIPMENT:





WARRANTY INFORMATION:

REPAIR PROCEDURE:

1. Remove the Meter Hood Sub-assembly.

Refer to the ETAS/TIS library applicable model and model year Repair Manual:

^ 2011-2012
Vehicle Interior- Interior Panels - "Trim: Upper Instrument Panel: Removal: Removal"

2. Install the Meter Hood Sub-assembly.

^ 2011-2012
Vehicle Interior - Interior Panels - "Trim: Upper Instrument Panel: Removal: Installation"

3. Verify the condition has been repaired.

4. Initialize the following systems if equipped:

^ Parking Assist Monitor System.

^ Power Door Lock Control System.

NOTE:
Issue of the Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.

© 2012 Lexus, a division of Toyota Motor Sales, USA