Assembly

NAVIGATION / MULTI INFO DISPLAY: MULTI-DISPLAY: REASSEMBLY

1. INSTALL MULTI-DISPLAY

2. INSTALL MULTI-DISPLAY CONTROLLER BRACKET A

(a) Install the multi-display controller bracket A with the 2 screws.





3. INSTALL MULTI-DISPLAY CONTROLLER BRACKET B

(a) Install the multi-display controller bracket B with the screw.





4. INSTALL NO. 2 EARTH WIRE

(a) Install the No. 2 earth wire with the screw.





5. INSTALL MULTI-MEDIA MODULE WIRE

(a) Engage the clamp and install the multi-media module wire.





(b) Connect the 2 connectors.

6. INSTALL MULTI-DISPLAY ASSEMBLY

(a) Install the multi-display assembly with the 4 screws.





7. INSTALL MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY

(a) Install the multi-display controller sub-assembly with the 3 screws.





(b) Engage the 2 claws and clamp.

(c) Install the new 2 tapes.





8. INSTALL UPPER INSTRUMENT CLUSTER FINISH PANEL

(a) Engage the 4 guides and temporarily install the upper instrument cluster finish panel as shown in the illustration.





(b) Install the upper instrument cluster finish panel with the 4 screws.





(c) Install the 2 new tapes.





9. INSTALL INSTRUMENT PANEL REGISTER CONTROL GEAR

(a) Install the instrument panel register control gear.





10. INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL RETAINER

(a) Install the No. 2 instrument panel finish panel retainer and No. 1 instrument panel finish panel retainer with the 5 screws.





HINT
Install the screws in the order shown in the illustration.

11. INSTALL NO. 3 INSTRUMENT PANEL FINISH PANEL RETAINER

(a) Install the No. 3 instrument panel finish panel retainer with the 3 screws.





(b) Engage the clamp and install the screw.





(c) Engage the 2 clamps and connect the 2 claws.





12. INSTALL SENSOR WIRE

(a) Align the pin of the sensor wire with the groove of the center instrument cluster finish panel assembly, and then install the sensor wire.





Text in Illustration





NOTICE:
* If the pin is damaged, replace it with a new one.
* Make sure that the pin fits into the groove securely.

(b) Engage the 3 claws.





(c) Install the sensor wire cover with the screw.

(d) Engage the 2 clamps.





Text in Illustration





(e) Using tape, secure the wire harness at the position shown in the illustration.

HINT
* If the tape has lost adhesion, replace it using tape that has enough adhesion to secure the harness.
* Install the tape at the position shown in the illustration.

13. INSTALL INSTRUMENT CLUSTER FINISH PANEL COVER

(a) Install the instrument cluster finish panel cover with the 5 screws.





14. INSTALL DISPLAY MODULE BOARD

(a) Install the display module board with the 2 screws.





(b) Connect the 2 connectors.





(c) Engage the 4 claws to install the lower center instrument cover.