C1517

POWER ASSIST SYSTEMS: POWER STEERING SYSTEM: C1511-C1514, C1517: Torque Sensor Circuit Malfunction

DESCRIPTION

The torque sensor converts the rotation torque input from the steering wheel into electric signals and sends them to the power steering ECU assembly.

WIRING DIAGRAM

INSPECTION PROCEDURE

NOTICE:
If the steering column assembly or power steering ECU assembly has been replaced, perform rotation angle sensor value initialization and torque sensor zero point calibration Programming and Relearning.

PROCEDURE

1. CHECK CONNECTOR CONNECTION CONDITION (TORQUE SENSOR - ECU)

(a) Check the installation condition of the torque sensor connector.

OK:

Torque sensor connector is securely connected to the power steering ECU assembly.

NG -- CONNECT CONNECTOR
OK -- Continue to next step.

2. CHECK POWER STEERING ECU ASSEMBLY (TRQV VOLTAGE)

(a) Turn the power switch on (READY).

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Text in Illustration

NG -- REPLACE POWER STEERING ECU ASSEMBLY Removal
OK -- Continue to next step.

3. CHECK POWER STEERING ECU ASSEMBLY (TRQ1, TRQ2 VOLTAGE)

(a) Turn the power switch on (READY).

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Text in Illustration

NG -- REPLACE STEERING COLUMN ASSEMBLY Removal

OK -- REPLACE POWER STEERING ECU ASSEMBLY Removal