Installation

1UR-FSE ENGINE CONTROL SYSTEM: ACCELERATOR PEDAL: INSTALLATION

1. INSTALL ACCELERATOR PEDAL





NOTICE:
* Avoid physical shocks to the accelerator pedal.
* Do not disassemble the accelerator pedal assembly.

(a) Connect the tip of the accelerator pedal rod to the bracket.

(b) Install the accelerator pedal with the 3nuts.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(c) Connect the accelerator pedal sensor connector.

2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

3. INSTALL COWL TOP VENTILATOR LOUVER RH Installation

4. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.