Replacement

AXLE AND DIFFERENTIAL: REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL: REPLACEMENT

HINT
* Use the same procedure for the RH side and LH side.
* The following procedure is for the LH side.

1. DRAIN DIFFERENTIAL OIL Service and Repair

2. REMOVE REAR DRIVE SHAFT ASSEMBLY

HINT
Refer to the procedure for Removal of the rear drive shaft assembly Removal.

3. REMOVE REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL

(a) Using SST, remove the rear differential side gear shaft oil seal.

Text in Illustration

SST : 09308-00010

4. INSTALL REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL (for 2GR-FSE)

(a) Using SST and a hammer, install a new rear differential side gear shaft oil seal.

SST : 09223-15030

SST : 09950-70010

09951-07200

Oil seal installation depth (A):

-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

NOTICE:
* Make sure to check the identification marks on the oil seals before installation because the parts numbers differ between the left and right sides.
* To ensure a proper seal, evenly tap in the rear differential side gear shaft oil seal.
* When installing the oil seal, tap it in until its surface is flush with the rear differential carrier.

(b) Apply MP grease to the rear differential side gear shaft oil seal lip.

5. INSTALL REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL (for 4GR-FSE)

(a) Using SST and a hammer, install a new rear differential side gear shaft oil seal.

SST : 09213-70011

SST : 09950-60010

09951-00410

09951-00620

09952-06010

SST : 09950-70010

09951-07100

Oil seal installation depth (A):

-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

NOTICE:
* To ensure a proper seal, evenly tap in the rear differential side gear shaft oil seal.
* When installing the oil seal, tap it in until its surface is flush with the rear differential carrier.

(b) Apply MP grease to the rear differential side gear shaft oil seal lip.

6. INSTALL REAR DRIVE SHAFT ASSEMBLY

HINT
Refer to the procedure for Installation of the rear drive shaft assembly Installation.

7. ADD DIFFERENTIAL OIL Service and Repair