Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: INSTALLATION

HINT
If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.

1. INSTALL REAR SPEED SENSOR

(a) Install the rear speed sensor with the bolt.





Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)

NOTICE:
Prevent foreign matter from attaching to the sensor tip.

2. CONNECT REAR SPEED SENSOR WIRE

(a) Connect the rear speed sensor wire.





3. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

5. INSPECT SPEED SENSOR SIGNAL

Test Mode Procedure