Removal

A960E AUTOMATIC TRANSMISSION: TORQUE CONVERTER AND DRIVE PLATE: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE COOL AIR INTAKE DUCT SEAL Removal

3. REMOVE ENGINE ROOM SIDE COVER LH Removal

4. REMOVE ENGINE UNDER COVER

5. REMOVE NO. 2 ENGINE UNDER COVER

6. DRAIN COOLANT Testing and Inspection

7. DRAIN AUTOMATIC TRANSMISSION FLUID Removal

8. REMOVE NO. 1 FLOOR UNDER COVER Removal

9. REMOVE NO. 2 FLOOR UNDER COVER Removal

10. REMOVE NO. 1 REAR FLOOR PANEL BRACE Removal

11. REMOVE FRONT CENTER FLOOR BRACE Removal

12. REMOVE OXYGEN SENSOR Removal

13. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal

14. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR Removal

15. REMOVE OUTSIDE AIR GUIDE PLATE RH Removal

16. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY Removal

17. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH Removal

18. REMOVE STARTER ASSEMBLY Removal

19. REMOVE FLYWHEEL HOUSING SIDE COVER Removal

20. REMOVE DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT Removal

21. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY Removal

22. SEPARATE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY Removal

23. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY Removal

24. REMOVE ENGINE REAR MOUNTING MEMBER Removal

25. SEPARATE CONNECTOR Removal

26. SEPARATE WIRE HARNESS Removal

27. SEPARATE WATER BY-PASS HOSE Removal

28. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY Removal

29. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR Removal

30. REMOVE TRANSMISSION CONTROL SHAFT LEVER RH Removal

31. REMOVE TRANSMISSION OIL COOLER Removal

32. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY Removal

33. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY Testing and Inspection