Rear Door Panel: Service and Repair

ENGINE HOOD / DOOR: REAR DOOR PANEL: DISASSEMBLY

1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

(a) Using a screwdriver wrapped with protective tape, disengage the 3 claws and remove the rear door inside handle bezel plug.





2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

(a) Using a screwdriver wrapped with protective tape, disengage the 2 claws and 2 clips.





(b) Disconnect the connector and remove the rear power window regulator switch assembly.

3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

(a) Remove the 2 screws.





(b) Using the clip remover, disengage the 8 clips.

(c) Pull out the rear door trim board in the direction indicated by the arrow.





(d) Remove the reference bosses from the rear door panel.

(e) Raise the rear door trim board to disengage the 3 claws and remove the rear door trim board together with the rear door inner glass weatherstrip.

(f) Disconnect the cables and each connector from the back side of the inside handle and the rear door trim board sub-assembly, remove the rear door trim board sub-assembly.





(g) Remove the 2 rear door trim board retainers (green) from the rear door trim board.

For Reassembly, reverse removal procedure.