Installation

2AZ-FXE EMISSION CONTROL: PCV VALVE: INSTALLATION

1. INSTALL VENTILATION VALVE SUB-ASSEMBLY

(a) Apply adhesive to 2 or 3 threads of the ventilation valve sub-assembly.

Adhesive:

Toyota genuine adhesive 1324, three bond 1324 or equivalent

(b) Using a ball joint lock nut wrench (22 mm), install the ventilation valve sub-assembly.

Torque : 19 Nm (194 kgf-cm, 14 ft-lbf)

NOTICE:
Use the formula to calculate special torque values for situations where a ball joint lock nut wrench is combined with a torque wrench Service Precautions.

(c) Connect the No. 2 ventilation hose to the ventilation valve sub-assembly.

2. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY Installation

3. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY Installation

4. INSTALL COWL BODY MOUNTING REINFORCEMENT RH Installation

5. INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL Installation

6. INSTALL WATER GUARD PLATE RH Installation

7. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

(a) Install the windshield wiper motor and link assembly Installation.