Disassembly

PARKING BRAKE: PARKING BRAKE ASSEMBLY: DISASSEMBLY

NOTICE:
When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

HINT
* Use the same procedure for the RH side and LH side.
* The following procedure is for the LH side.

1. PRECAUTION (w/ Navigation System)

NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT Removal

3. DISABLE BRAKE CONTROL Removal

4. REMOVE REAR WHEEL

5. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY Removal

6. REMOVE REAR DISC Removal

7. REMOVE NO. 3 PARKING BRAKE SHOE RETURN TENSION SPRING

(a) Remove the No. 3 parking brake shoe return tension spring.





8. REMOVE NO. 2 PARKING BRAKE SHOE RETURN TENSION SPRING

(a) Remove the No. 2 parking brake shoe return tension spring.





9. REMOVE PARKING BRAKE SHOE HOLD DOWN COMPRESSION SPRING (for Front Side)

(a) Using SST, remove the parking brake shoe hold down compression spring as shown in the illustration.





SST : 09718-00011

10. REMOVE PARKING BRAKE SHOE STRUT

(a) Pull the No. 1 parking brake shoe assembly towards the front of the vehicle by hand as shown in the illustration.





(b) Remove the parking brake shoe strut.





11. REMOVE PARKING BRAKE SHOE HOLD DOWN COMPRESSION SPRING (for Rear Side)

(a) Using SST, remove the parking brake shoe hold down compression spring as shown in the illustration.





SST : 09718-00011

12. SEPARATE PARKING BRAKE SHOE LEVER

(a) Expand the No. 1 and No. 2 parking brake shoe assemblies outward by hand and pull downward to separate them from the backing plate.





(b) Separate the parking brake shoe lever from the No. 2 parking brake shoe assembly





13. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET

(a) Remove the parking brake shoe adjusting screw set.





14. REMOVE NO. 1 PARKING BRAKE SHOE RETURN TENSION SPRING

(a) Remove the No. 1 parking brake shoe return tension spring.





15. REMOVE PARKING BRAKE SHOE LEVER

(a) Using needle-nose pliers, remove the parking brake shoe lever from the No. 3 parking brake cable assembly as shown in the illustration.





16. REMOVE PARKING BRAKE SHOE HOLD DOWN SPRING PIN

(a) Remove the parking brake shoe hold down spring pin (for front side).





(b) Remove the parking brake shoe hold down spring pin (for rear side).