Installation

PARKING BRAKE: PARKING BRAKE PEDAL: INSTALLATION

1. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

(a) Install the parking brake control pedal assembly with the bolt and 2 nuts.

Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)

(b) Connect the parking brake switch connector.

(c) Engage the 3 wire harness clamps.

(d) Install the No. 1 parking brake cable assembly with the 5 bolts and nut.

Torque : 15 Nm (148 kgf-cm, 11 ft-lbf)

(e) Engage the clamp.

(f) Temporarily install the lock nut.

HINT
After adjusting parking brake pedal travel, tighten the lock nut.

2. CONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY

(a) Connect the No. 1 parking brake cable assembly to the No. 1 parking brake pull rod sub-assembly as shown in the illustration.





Text in Illustration





Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

3. INSTALL NO. 3 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY

(a) Install the No. 3 belt anchor reinforcement sub-assembly with the 4 bolts.

Torque : 27 Nm (275 kgf-cm, 20 ft-lbf)

(b) Engage the 2 wire harness connectors.

4. INSTALL NO. 2 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY

(a) Install the No. 2 belt anchor reinforcement sub-assembly with the 4 nuts.

Torque : 27 Nm (275 kgf-cm, 20 ft-lbf)

(b) Connect the indoor electrical key antenna assembly connector.

(c) Engage the wire harness clamp.

5. INSTALL FRONT SEAT ASSEMBLY LH

HINT
Refer to the instructions for Installation of the front seat assembly Installation.

6. INSTALL FRONT SEAT ASSEMBLY RH

HINT
Perform the same procedure as for the LH side.

7. INSTALL AIR CONDITIONING UNIT

HINT
Refer to the instructions for Installation of the air conditioning unit Installation.

8. ADJUST PARKING BRAKE SHOE CLEARANCE AND PARKING BRAKE PEDAL TRAVEL Adjustments

9. INSPECT BRAKE WARNING LIGHT Adjustments