Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: INSTALLATION

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure is for the LH side.
* If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.
* The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

(a) Install the rear axle hub and bearing assembly Installation.

HINT
* The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.
* If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.

2. INSPECT REAR AXLE HUB BEARING LOOSENESS Rear Axle Hub

3. INSPECT REAR AXLE HUB RUNOUT Rear Axle Hub

4. INSTALL REAR DISC Installation

5. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY Installation

6. CONNECT REAR SPEED SENSOR WIRE

(a) Connect the rear speed sensor wire connector to the rear speed sensor.





7. INSTALL REAR SUSPENSION ARM COVER Installation

8. ADJUST PARKING BRAKE SHOE CLEARANCE AND PARKING BRAKE PEDAL TRAVEL Adjustments

9. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG Installation

10. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

(a) Connect the cable to the negative (-) battery terminal and close the front luggage compartment trim cover.

(b) Connect the reservoir level switch connector.

(c) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

12. INSTALL LUGGAGE COMPARTMENT FLOOR MAT Installation

13. CHECK FOR SPEED SENSOR SIGNAL

Test Mode Procedure