Installation

1UR-FSE ENGINE CONTROL SYSTEM: ACCELERATOR PEDAL: INSTALLATION

1. INSTALL ACCELERATOR PEDAL

(a) Install the accelerator pedal with the 2 nuts.





Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

NOTICE:
* Avoid physical shocks to the accelerator pedal.
* Do not disassemble the accelerator pedal assembly.

(b) Connect the accelerator pedal sensor connector.

2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.