Replacement

TIRE AND WHEEL: TIRE PRESSURE WARNING ECU: REPLACEMENT

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE RADIO RECEIVER ASSEMBLY

HINT
Refer to the instructions for removal of the radio receiver assembly Removal.

3. REMOVE TIRE PRESSURE MONITOR ECU

(a) Disconnect the connector.

(b) Remove the 2 bolts and tire pressure monitor ECU.





4. INSTALL TIRE PRESSURE MONITOR ECU

(a) Install the tire pressure monitor ECU with the 2 bolts.





Torque : 4.5 Nm (46 kgf-cm, 40 in-lbf)

(b) Connect the connector.

5. INSTALL RADIO RECEIVER ASSEMBLY

HINT
Refer to the instructions for installation of the radio receiver assembly Installation.

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

7. REGISTRATION OF TRANSMITTER ID

HINT
Registration.

8. INSPECT TIRE PRESSURE WARNING SYSTEM

HINT
Test Mode Procedure.