Installation

SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY

(a) Check that the engine switch is off.

(b) Check that the battery negative (-) terminal is disconnected.

NOTICE:
After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.

(c) Install the center airbag sensor with the nut and 2 bolts.





Torque : 18 Nm (184 kgf-cm, 13 ft-lbf)

NOTICE:
* If the center airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
* When installing the center airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(d) Check that there is no looseness in the installation parts of the center airbag sensor.

(e) Connect the holder (with connectors).

(f) Check that the water-proof sheet is properly set.

2. INSTALL CONSOLE BOX ASSEMBLY Installation

3. INSTALL CONSOLE BOX REGISTER ASSEMBLY Installation

4. INSTALL CONSOLE BOX PLATE Installation

5. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation

6. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation

7. INSTALL CONSOLE UPPER PANEL ASSEMBLY Installation

8. INSTALL FRONT CONSOLE UPPER PANEL GARNISH Installation

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

10. PERFORM INITIALIZATION

11. INSPECT SRS WARNING LIGHT