Removal

LIGHTING: HEIGHT CONTROL SENSOR: REMOVAL

HINT
* Use the same procedures for the RH side and LH side.

* The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE HEIGHT CONTROL SENSOR SUB-ASSEMBLY FRONT

(a) Remove the front tire.

(b) Disconnect the connector.

(c) 2WD:





Remove the nut and sensor link from the lower arm.

(d) 4WD:





Remove the bolt and sensor link from the lower arm.

(e) Remove the 2 bolts and sensor.





3. REMOVE HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR

(a) Remove the rear tire.

(b) Disconnect the connector.

(c) Put matchmarks on the sensor link and bracket.





(d) Remove the 2 bolts and sensor.