Removal

2GR-FSE COOLING: COOLING FAN MOTOR: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE COOL AIR INTAKE DUCT SEAL Removal

3. REMOVE ENGINE ROOM SIDE COVER RH Removal

4. REMOVE ENGINE ROOM SIDE COVER LH Removal

5. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

6. REMOVE NO. 1 AIR CLEANER INLET Removal

7. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE Removal

8. REMOVE AIR CLEANER FILTER ELEMENT

9. REMOVE AIR CLEANER CASE

10. REMOVE NO. 4 RELAY BLOCK





Disconnect the connector.

(a) Disconnect the wire harness clamp.

(b) Remove the 2 bolts and relay block.

11. REMOVE ENGINE UNDER COVER (for 2WD)

12. REMOVE ENGINE UNDER COVER (for 4WD)

13. DRAIN ENGINE COOLANT Service and Repair

14. REMOVE RADIATOR RESERVOIR ASSEMBLY Removal

15. DISCONNECT NO. 1 RADIATOR HOSE

16. DISCONNECT NO. 2 RADIATOR HOSE

17. REMOVE ENGINE ROOM ECU OUTLET DUCT

18. REMOVE FAN SHROUD WITH FAN AND MOTOR

(a) Disconnect the cooling fan ECU connector.





Detach the 3 claws, and then remove the fan shroud with fan and motor.