Installation

U660E AUTOMATIC TRANSAXLE: DIFFERENTIAL OIL SEAL: INSTALLATION

1. INSTALL TRANSAXLE CASE OIL SEAL

(a) Using SST and a hammer, install a new oil seal to the transaxle case.





SST : 09316-10010

SST : 09950-70010

09951-07100

Oil seal installation depth:

-0.5 to 0.5 mm (-0.020 to 0.020 in.)

(b) Coat the lip of the oil seal with MP grease.

2. INSTALL FRONT TRANSAXLE CASE OIL SEAL

(a) Using SST and a hammer, install a new oil seal to the transaxle housing.





SST : 09308-14010

Oil seal installation depth:

-0.5 to 0.5 mm (-0.020 to 0.020 in.)

(b) Coat the lip of the oil seal with MP grease.

3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH Installation

4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH Installation

5. INSTALL FRONT AXLE ASSEMBLY LH Installation

6. INSTALL FRONT AXLE ASSEMBLY RH

HINT
Use the same procedure described for the LH side.

7. INSTALL FRONT SUSPENSION LOWER NO. 1 ARM LH Installation

8. INSTALL FRONT SUSPENSION LOWER NO. 1 ARM RH

HINT
Use the same procedure described for the LH side.

9. INSTALL TIE ROD ASSEMBLY LH Installation

10. INSTALL TIE ROD ASSEMBLY RH

HINT
Use the same procedure described for the LH side.

11. INSTALL FRONT SPEED SENSOR LH Installation

12. INSTALL FRONT SPEED SENSOR RH

13. INSTALL FRONT STABILIZER LINK ASSEMBLY LH Installation

14. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT
Use the same procedure described for the LH side.

15. INSTALL FRONT AXLE HUB NUT LH Installation

16. INSTALL FRONT AXLE HUB NUT RH

HINT
Use the same procedure described for the LH side.

17. INSTALL FRONT WHEELS Installation

18. ADD AUTOMATIC TRANSAXLE FLUID

HINT
Procedures

19. ADJUST FRONT WHEEL ALIGNMENT

HINT
Front Wheel Alignment

20. CHECK ABS SPEED SENSOR SIGNAL

HINT
Test Mode Procedure